All user reviews for the Rocktron PatchMate Loop 8 Floor

I use it for 11 months.
This is my first pedal switch. It is mechanically robust.
I just want to draw attention to a malfunction on the input / output passive active /.
At first I used it in config passive input - output passive, everything was fine. I recently wanted to make a test active input, and that given to:
for active input - output active: big hum
More according to the manual, when using the active input signal must be present on both the passive and active output, which is unfortunately not the case (no sound output passive). After sending in for repair at the importer it has been found that all the models they had in stock had the same symptom ... So my camera is still not returned from service, the ball is in the camp ROCKTRON ... there would perhaps have a pb in the production line ....
So be careful before you buy

Patch programmable pedals and MIDI driver mode pedals (do not fit into a 19-inch). Relay connector, so true bybass + possible (programmable also = cool!) Of equipment connected or not the chain of pedals.

Extremely simple to use, the manual is there for something.
You just know one thing before ordering: there are several versions of the software, the latest being the best. In my case, I have asked Rocktron to send me the chip with the latest version, what they did for free.

no problem!

been using it for 2 months.
The pros:
does nothing to distort the sound, no latency. Enormous possibilities of combinations. Pilot can switch to channel preamp / amp (Jack).
The -:
impossible to reverse the order of pedals without Disconnect the terminal! Version of the software to check before buying!