Table 3-way rack (line / phono x2 and mic / line / phono)
Ultraglide crossfader
XLR microphone
adaptation for 12 volt BNC lamp
Equalizer has led
Counter BMP (CH2 and CH3)
Kill Effect

UTILIZATION

I use it mainly for small evening entertainment but also for the mix, I use a lot the crossfader and effects kill, BMP counters are used to guide the user about
use with lamp (BNC)
often in motion (which implies décabler and constantly rewire)

SOUNDS

Lightweight full blast ball
surprising power in headphone output
sometimes its too sharp output

OVERALL OPINION

For me, this is since 2003 that I own this table
I advise to start a low cost (€ 150 a time)
avoid too much travel, RCA connectors games takes a force to disconnect the cables
the sliders, to crack after about a year of use (I speak of a common use, not excessive) the crossfader when he was a positive one, it is changeable (with € 25-30) prefer to repair house to change, if not anticipate big budget (one of a clip to tighten the contacts only) ... PROVIDE A BOMB SPECIAL CONTACT beside you, before a convenient mix, your story public do not think your CD is scratched, or you do from scratch ...

Tip: before taking the DX 626 to tour the tables in the same range of tables in the same config. exist in any other brand with the design slightly modified ...

Beware always of a low-cost devices, are not reliable, but there have ...