One issue that many people have with dual-distortion pedals is that often both ‘sides’ (the two channels) consist of the same voicing, whereas you change those voices by way of the EQ, how much Gain you give each, etc. That is NOT the case with the Eris. Both sides are completely different, with one being a low to moderate gain (more ‘classic’ sounding), whereas the other is heavy hitting and modern. Both have their own Gain and Volume controls, but the sculpting aspects are different as well. The low-to-moderate gain side has a Tone control and a high-cut control, so that you can dial in enough top end, while tapering off any excess shrill or bite. The high-gain side has both a Bass and Treble control. To operate the Eris, there is a master footswitch to turn it on and off (with LED indicator), and a separate footswitch that toggles between the two channels (each with its own LED indicator). Operation is relatively straight-forward, based on the above information, but what I noticed is that to dial into a good sound requires some tweaking of the amp. For many pedals (or when using my amps in general), I tend to have the Bass slightly less than 12-noon, the Midrange around 12-noon or a touch higher, and the Treble around 1-o’clock or a touch higher. These settings vary at times, but those are typical. However, I find the Eris somewhat vivid in the higher EQ range. I’m not suggesting that it is trebly or bright, but that in order to get that midrange, chewy sound (particularly with the high-gain channel of the Eris) you need to back off on an amp’s treble while boosting either/or the bass and midrange. Once I did that, the Eris really shone and came to life – bolder and darker (not muddy), yet incredibly clear in the mix with a punch. Now, to describe the characteristics of each channel, although this will depend on the pedal’s settings, as well as an amp’s settings. The lower gain side is extremely mild with the gain down, which makes for a fantastic clean boost, but also when wanting a hint of hair to a clean signal or to add some dazzle to an already dirty tone. Although a distortion pedal, this channel very much has an overdrive quality, and when turned up full it is reminiscent of classic rock. The high-gain channel is thick and meaty, so much so that the gain set at about 10-o’clock is plenty on a clean channel when riffing and going for that fat crunch tone. Dialing up more gain then gets into a distortion-fuzz-like quality, still sounding great for rhythm, although the added saturation does lead playing more justice. The high-gain channel can be added to a dirty amp, although the pedal’s gain should be turned all the way down and the amp’s gain reduced accordingly. A definite part of the Eris’ sound sculping ability is obvious when working the EQ knobs. There is a tremendous difference in bass and treble responses that make it flexible enough for the darkest and brightest amps out there. Moreover, the EQ controls are very touch sensitive – a minor tweak goes a long, long way… what sounds too dark can sound too bright with only a slight turn (with an adjustment between always sounding just right). Consequently, when you get your tones dialed in, I suggest a small pen or marker indicator on the controls, just in case they get moved between gigs. Overall, and with various distortions in my studio, the Eris sounds as good in most respects, but what separates it from the rest is the ‘bigness’ of its sound, but also its diversity. Two very different channels (as though two pedals in one) and a huge array in tone possibilities. I find it difficult to believe that one could not dial into preferred tones with either channel and with any gear in use. I tried this pedal on various platforms, both solid state and tube, and it sounds fantastic no matter the environment or cab IR.
Not all fuzzes are created equal, and the Nemesis + Fuzz/Expression, by DPFX (direct in Greece) proves that point. (FYI: available on Reverb, but do search Nemesis fuzz, since there is a Nemesis delay by another company). Some may be put off by all the options that exist with the Nemesis, as opposed to one or a few knobs in which to turn, but if you’re looking for a wide array of palette choices for your compositions, and you’re a fuzz nerd, the Nemesis will rock your socks off. It has a powerful sound, and so it coordinates best with clean amps, although it embraces slightly dirty/gritty amps rather well by controlling the gain on both. The sounds vary considerably with this pedal, and although the accompanying demo alludes to this fact, it only scratches the surface. In fact, the demo runs 10-minutes long, and so I did not want to belabor the issue as I avoided demoing how it can sound by rolling back the guitar’s volume (to clean up the tone). Consequently, the demo includes both bold rhythms with some accompanying lead licks throughout a number of settings to get the Nemesis’ point across. Nonetheless, the demo covers a lot of ground. Starting at the top of the pedal, there is a three-band EQ, and what I like about this EQ is that it provides a good range of dark-to-bright without exaggeration or pointlessness… using a lot of bass or midrange does not make the signal muddy, nor does using a lot of treble make it harsh. The Frequency knob is pure delight and you can achieve anything from heavy and menacing to edgy and cutting in your tone, an element that coordinates well with the EQ section. The Sharp knob allows you to dial in the Resonance, so that the tone cuts through less or more – in a way, it adds ‘edge’ to the sound. The Resonance also can be adjusted (hi or lo) via its toggle switch, thus expanding the harmonics and overtones. The Gain knob ranges from dirty to nasty, but without becoming too saturated, unless fully cranking the control (which still cleans up nicely via the guitar’s volume). You can provide some Gain emphasis with its own toggle switch, making the sound more aggressive with a modest increase in volume. Of course, there is a Volume control, and there’s plenty of volume on tap; for the entire demo I kept it no more than half-way. What I like is that pushing the Gain (even when switched to hi-gain) does not boost the signal that much, which means you don’t have to be overly concerned about balancing volume with gain. The icing on the cake with this pedal is its expression control, which sweeps through the Frequency – and this sounds very different depending on which Resonance you select (hi or lo). All of these features allow you to incorporate some modest fuzz, which also sounds like mild distortion with lower Gain settings and if dialing back on your guitar’s volume, but also heavy psychedelic doom Metal. The range of fuzz is very impressive, indeed. The expression control option is for those experimenters who want to explore realms that are unique, yet musical. The Nemesis is awesome on its own, but the expression option definitely sets it apart from fuzz pedals that try to be unique. If you fast-forward to the 6-minute mark in the demo, you will hear some active knob tweaking while playing, that later resorts to use of an expression pedal. Nemesis is slightly larger than the average sized pedal, but it contains a lot of controls and options in its footprint. As well, you can tell DPFX cares about its boutique-quality perception and reputation. All of the pedal is hand-painted (using spray paint and stencil work) and the logo on the face of the pedal is etched on the aluminum chassis. Finally, since the Nemesis does have ‘distortion-like’ qualities, with fat and grainy textures, this pedal likely will appease musicians who may not be fuzz-fans.