Radial Engineering MC3
+

Radial Engineering MC3

  • Like
  • Tweet
  • +1
  • Pin it
  • Submit
  • Mail

Radial Engineering announces the MC3 studio monitor controller; a 'straight wire' passive monitor switcher and headphone amp designed to provide smaller production studios with a monitor, sub and headphone management system.

Designed for active nearfield monitors, the MC3 is equipped with two  stereo outputs and a separate send to feed a sub-woofer. Each may be  set using a trim control allowing switching between loudspeakers. Separate on-off switches allow any or all to be selected at one time and an adjustable dim switch may be activated to temporarily reduce the monitor level. A single control  acts as the master for setting the desired listening level. All  monitor switching and level controls are passive, thus ensuring no extra amplifiers are inserted in between the source  recording system and playback monitors. Unlike active switchers that  color the tone, the MC3 is completely passive. In other words, it  employs ‘straight wires’ between the input and output with only gold sealed relays and a variable resistor in between. This  is designed to ensure the signal coming from the recorder to the monitors is not  altered in any way.

 

The MC3 is equipped with a headphone amp that is capable of  driving two sets of headphones at the same time. A separate ear-bud  output makes for connection to iPod type environments. All outputs  may be summed mono for quick phase check and AM radio listening simulation.

 

The MC3 includes a 14 gauge steel enclosure with a protective zone  to keep switches and controls out of harms way.

 

For more information please send an email to www.radialeng.com.

  • Like
  • Tweet
  • +1
  • Pin it
  • Submit
  • Mail

Viewers of this article also read...