TC Electronic G-Sharp

Model Rack.
Connectors: Midi / jack
-Reverb:
TC Classic Hall • Pro Studio • Classic Spring • Spring • Plain Gold Plate Tin Plate • • • Silver Plate Tin Plate • Ambience • Stomp • Club • Soft Room • Tiled Room • Church • Concert Hall
-Modules:
Vintage Phaser • Smooth Phaser • Tremolo Swell Tremolo • Vibrato • Hard • • Lush Chorus • Flange Soft Chorus
-Delay:
• Soft Delay Delay Delay • Tape • Lo-Fi Delay • Dynamic Delay • Delay • PingPong Delay Slapback
A little tuner that would have been top.

UTILIZATION

The g sharp is easy to use tap tempo, simple parameter settings.
The g switch is also, unless you want 36 different sounds in order to walk the stage.

SOUND QUALITY

My config is as follows:
engl powerball head + cabinet + VC30 engl z5 + g + g sharp switch (g pedalier the sharp stereo cable connected).
My jacks are wav planet, in fact, it is very important to maximize the quality of the wiring because I tried and I can tell you that the sound changes! Jack 6 m skyscraper -> head + 2 jack 1.5m for the effects loop.
I am totally satisfied with the sound, the g sharp enough for me, Since I only use reverb and delay.

OVERALL OPINION

I use it for one week, so to do with time.
This is my first model in a rack, but I had a lot of multi effect before, the ToneLab SE just before.
But that's another quality of the effects, much more suited to be inserted into a loop!
Value, it's clear that I have no hesitation in buying it! I put that 9 because it's been recently that I have, but it is very good!

See previous notice

UTILIZATION

Very simple and intuitive, almost no need for the record, except to understand that at the beginning There is no pre-existing presets, you have to create yourself, so we start from scratch at the beginning.
Do not get excited on the load button (like me hehe!)
one regret: the limited number of parameter editable, so 8.

SOUND QUALITY

Then the sound: c g is not a force!
already + c is an effect reverb, period.
I use the loop xv112e carvin my ds connected to a speaker cabinet mesa corrected 2 * 12.
the sound is clean, ok chorus, the limit I prefer the vibrato.
The flanger is a throw for me (not enough parameters).
The Smooth Phaser is an error, the vintage is ok (I c is on compared to my small stone us, the fight is unequal!).
the delays are good, there is still no level of a Quadraverb, but for the price, c is honorable, the guitar is not an instrument n fi.
the reverbs are complete and varied the air.
The tremolo does its job.

OVERALL OPINION

Shame about the low cumulative effects, but for the price of a good pedal is more than one, c is programmable. it is still too much effects anyway.
you should know that There is no button on / off. c is "on" at all.
I got the cover a nice 250 + dedicated + pedalboard. no notable change in latency presets, I have not tried the midi.pas Box of external power supply, is ca c, ca traine not pit.
Congratulations to effect center, delivered in '24

in total, very satisfactory value for money.

Two effects processors, one for modulation (chorus, flanger, tremolo and delay) and the other for reverbs
It is digital, are theoretically are edited via an editor provided on the site tc. simple connection jack (L / R for stereo) and SPDIF digital inputs and outputs.
1U and Killdry for use in a parallel loop.

UTILIZATION

Configuration architecture simple, not more complicated than a foot to settle, the sounds are easy to remember, easy to edit and save. The manual is clear enough. However, it should be noted that the parameters available for the sounds are few, and we can not change the sound drastically (which is not necessarily a fault, it avoids the excesses). We may not receive a reverb and an effect of modulation / delay.

SOUND QUALITY

While the sound quality .... well I'm not a big fan of effects but hey, I got some memories that left me more or less happy. It gives very nice sounds, but totally distorts the original sound of the guitar, no bypass, with all effects off, the sound changed dramatically, and thus serves as a working basis for the effects .. . then on the hardware a bit cheap, it can do, if ...
rendering effects, however, is very nice, I repeat, it's really a shame that the incoming signal is so radically changed .. no bypass .. For me, the only acceptable use of this effect is to insert it into a parallel effects loop adjustable with Killdry engaged, so that the G-Sharp will then return so that the treated signal that can mix with the dry signal (no effect) real amp, via a setting on the amp. It is the only way I found to keep the color of my original sound ..

OVERALL OPINION

I used it 6 months .. It was fine on my previous material, and other parameters in a parallel loop. but I changed to an all-tube amp with an H & K parallel loop as well, but I want to use as a serial loop to insert a volume pedal, and therefore, catastrophe, I end up with a sound far below in quality than gross out my amp ..
Also a concern in this multi purpose. There is an adjustable input level, with an LED whose color indicates the level (red = it saturates the multi purpose so you have to keep it green / orange, with just a few short passages in red) .. good, then very simple: seeing if you can use the multi effect to its nominal operating level, bin level is very much amplified, thus saturating the amp .. if you want to find a level similar to that sent by the receiver, it must lower the level of entry into the G-Sharp, who works at a level so low, and eats the whole dynamic of the more dynamic delay which is very nice snaps systematically, since its n'atteind never a normal threshold to cut the impact .. brief .... not very good ..