transistor amp, enjoying technology "VIRTUBE" (simulation of tube sound), 2 HP 12-inch BUGERA, an input IN in frontage, front-panel headphone jack, effects loop on the back, you can disconnect the two HP back.
A clean channel with gain, bass, mid, treble, channel select switch, an overdrive channel with gain, bass, contour, treble, volume 1 of the drive channel, 1 volume pot selection of onboard effects (4 dedicated with chorus / delay, chorus only for 4, 4 for the flanger, delay alone for 4), effects level adjustment, setting the onboard reverb and master overall. the switch is also the front. Note that the effect VIRTUBE be disconnected by a switch on the front.
all this good, "Tolex" is pretty well finished and the corners are protected by solid angle of aspect, we do not feel like buying plywood dung, it's heavy and hulk!! a good point!!
UTILIZATION
the booklet supplied with the amp is therefore (in several languages), I must admit I have not opened more than that, but it has the merit to exist ....
we easily find a good sound, the knobs are reactive throughout the stroke, the mean change from safe handling, very good!!
the config is obvious, it's classic!
SOUNDS
I play mainly with metal, I have several guitars to get (a basswood LTD, a BC Rich basswood, a CHARVEL Alder, a mahogany CORT), with different configurations of microphones and tunings.
my applications are different that I had to find a compromise for the clean sound that I use with my pedals (
BEHRINGER TO800 in booster BOSS MT2 for heavy metal, and IBANEZ
DS7 for rock). Finally, it goes very well with each of my guitars!!
Note that I am always engaged VIRTUBE, you really feel the difference with / without, the output level is boosted, the sound is "warm", even light ....
I never had any tube amp, but its got me so completely satisfied ...
setting my clean channel: gain 2, bass, midrange and treble to 6, 6 reverb, delay one set position 8 with FX to level 2.
without pedals, the resulting sound is clear, full, it sounds great with all my guitars, though the sound is different because of different woods and pickups.
I use the overdrive channel with a very slight overdrive which I add in my
TO800 boost for sounds blues / rock (with my CORT), it makes very DIRE STRAITS in mind, really excellent!!
my overdrive channel adjustment: gain to 0.5, max 1, 5 bass and contour, treble at 4, volume 5. same setting of reverb and FX.
saturation obtained on the overdrive channel (without external effect) is more typical that big overdrive distortion, it takes a bold and well, you can easily change the setting contour: either you dig the sound by removing the media and there it sounds hard rock, or boost the mids and it was his typed a powerful lead.
on-board effects, they have the merit of being there, it's not bad for a beginner, but you get better things with pedals dedicated for there the effects are not configurable, except adjust the depth and choose among the presets imposed ....
However, it sounds really pretty ...
OVERALL OPINION
I bought it earlier this year.
before I had a Peavey Vypyr, but I have not hooked to the modeling system, I spent my time fiddling with knobs and seek her. too much of his kills the sound, in my opinion ...
there, I have a single sound, which is fine with me, finally, the Simple is good ...
I love everything about this amp, except for the limited effect because of missing settings.
value for money is excellent for an 2X12 mounted with good HP, we get very good sounds, not only for the metal at that.