Log in
EN
FR

MXR Dynamic or volume pedals

Series

27 products found

Categories
Series
Filter
Sort by
MXR
Evaluation
  • Reviewed or not
  • Editor’s award
  • Reviewed by Audiofanzine
Availability
  • Available or not
  • Sold new or used
  • Sold new
  • Sold used
Must-have products
  • All products
  • Flagship products
  • Best rated products
  • Hot products
  • Popular products
Price
  • Freeware
€
Clear
Sort by
  • Popularity
  • User ratings
  • Price - low to high
  • Price - high to low
  • Used price, increasing
  • Used price, decreasing
  • Name (from A to Z)
  • Name (from Z to A)
  • Added on
Choose a category
Selected category: Dynamic or volume pedals
Choose a series
Sort results
  • Popularity
  • User ratings
  • Price - low to high
  • Price - high to low
  • Used price, increasing
  • Used price, decreasing
  • Name (from A to Z)
  • Name (from Z to A)
  • Added on
Filter results 27 results found
Brands
Evaluation
Availability
Must-have products
Price
  • Freeware
Show results

The best MXR Dynamic or volume pedals reviews

The reviews Audiofanzine members found the most helpful.
  • « Good Clean Boost »

    The MXR Micro Amp M-133 is the most basic pedal you can find. An input from your guitar, an output to your amplifier, a power jack and one volume knob, and that’s it. It’s very similar in structural design to the Phase 90 and it’s the same size: 2 ½” by 4 ½” by 5 ½”. There is a red LED that lets you know when the pedal is engaged and the pedal can be powered by a 9 volt battery or by an additional power supply. UTILIZATION This pedal is a one trick pony, but you are able to use that trick in many different ways. Basically all this pedal does is boosts your signal, and this will do different things depending on where you put it in your signal path. In front of a tube amp this pedal can push you over the edge if the amp is set on the verge of breakup, while retaining your tone. When used in the effects loop of an amp this pedal can provide a huge boost in volume if needed that is much cleaner than when it’s used in front of the amp. This pedal is also handy to match the volume of guitars. For example if you use low output single coils in a Stratocaster and then switch off to a hot rodded Les Paul there will be a change in volume during a gig. Kick this pedal on while you play the Strat and off while you play the LP and you wont have to be constantly changing your volume knob on your amp during the show SOUND QUALITY This pedal does not suck any noticeable high end off of your tone, so I would say the bypass is very good. This pedal is not an overdrive pedal, but can be used to push an amp into that territory if it’s placed before the input of an amp and it does that while staying clean and true to the tone that you start with. I mostly use this pedal in the effects loop of my amplifiers because I don’t need a change in preamp gain/volume, but I prefer a super clean boost of volume. This pedal works wonders here. What you put into this pedal is what you get out, only at a higher volume. I have experienced no loss of tone or additional noise when used with several different guitars and amps. OVERALL OPINION Overall I think this is a great pedal to have in your arsenal. It can push the front end of your amp, provide tons of volume boost in the loop, match signals for different guitars during a gig, and regain a quality signal if many pedals are used in succession. It’s built like a brick and it doesn’t take a lot of space on your board. I think it’s a great pedal, and I would suggest it to anyone who would need a boost.

  • « Very solid compressor »

    The MXR Dyna-Comp is probably one of the more famous compressors out there. It's been around for who knows how long, and it's been part of rigs since before I was born. The ability to squish the notes works awesome for clean tones, and it can actually be used as a bit of a solo aid as well, assuming you don't plan on squishing the piss out of your tone. There are very few compressors out there as readily available as this, as well as being as musical sounding as this one. UTILIZATION MXR pedals are put into very strong housings. You could jump on this from the balcony, and I bet it would still survive. The only real issues I ever see with these are that the switches will sometimes go, but that's after years and years of hard touring abuse. I've seen people spill beers on these without any issues at all. Using it is very easy as there are only two knobs. You simply adjust the two knobs to the amount of compression you're looking for, and you're good to go. There are a few sample settings in the manual, and if you want more info, you can look in there, but considering how easy this pedal is to use, it's really not needed. SOUND QUALITY The sound is great. For clean tones, if you ever wanted that spanky kind of clean sound, this is the pedal you're looking for. You can squish the clean tone enough to where it sounds a lot more even and not nearly as "peaky" as clean tones tend to be. Country cleans are pretty much always heavily compressed, and this can do that kind of tone in spades. I don't really recommend using this on rhythms too much as it tends to be a bit too compressed, but on leads, it can be a pretty sweet lead boost that helps give you some extra sustain without harming the original tone too much. OVERALL OPINION If you're looking for a solid compressor for the price, this is probably the one you want to get. There are better ones out there such as the famous Keeley Compressor, but that's very expensive, and it's not exactly necessary for everyone. While that happens to be my main compressor, this one is great in a pinch, and I find myself using it whenever I go to a store to test out clean tones.

  • « Think: VOLUME! »

    The MXR Boost/Line Driver is the type of gear that I've been searching for. what it does, it does simply and pretty darn good. It's built like a tank, like most MXR/CAE products. It has one footswtich, one knob and one led. It doesn't take a rocket scientist to work this one guys. - 0 to 20 db knob - in and out jacks - blue led when engaged - dark grey casing - runs on 9 volt battery or power adapter UTILIZATION I'm sure this pedal can do more but for my application, I only use it as a pure volume boost. I run it through the loop of my Marshall DSL. It can make your sound INSANELY loud. I rarely push it past around 2 or 3 db of volume boost, mainly because it just is just too loud unless you're playing an arena. Even using it in this fashion, it gives your tone a little bit of a treble boost it seems, along with the added volume. SOUND QUALITY The one thing about this pedal is more me nitpicking than anything. The volume it gives is GREAT. You can boost your own solos and not have to worry about whether or not the soundman is sleeping or not paying attention. It does seem to add a slight artificial treble or mid to your tone. It's not bad but it feels like it takes a little gain away at the same time it feels like it's adding gain. Confusing? It's hard to explain. It's definitely not a deal breaker but it does color the tone just a tad. The majority of people in your audience are not going to notice this at all so you're ready to rip those notes! OVERALL OPINION As I said earlier in this review, the MXR MC401 is exactly what I'd been looking for to give my leads and solos a volume boost without relying on a sound tech that doesn't know my band's music. For the $65 price I paid for this, I'd do it again in a heartbeat. It's also a very compact pedal so it won't take up a ton of space on your board. I've yet to try it through the front of my amp as a traditional boost but I didn't buy it for that.