« On-Air 2000M2 as multitrack recording console »

These digital broadcast consoles can be used in traditional music recording studios with the right configuration of modules and a LOT of wiring. Mine started out life in 2002 as a 12 fader producer's console for Mississippi Public radio, was never used for on-air or regular general production. A very low mileage unit only used for a once a week program. The eBay seller had stripped out the modules, I had to track down all the ones I needed over a period of time from multiple sources. I did later find an additional bucket section, turning it into an 18 fader console. I decided to configure the single left bucket for all the line level sources, so settled on 2 stereo analog modules, an analog hex module, 2 digital modules, and a digital hex module. The left 3 faders are for 10 stereo analog sources, and the right 3 faders 10 digital sources. The two right hand buckets have 2 each stereo analog modules, and 4 mic modules, totaling 8 stereo and 8 mono inputs. The mic inputs are normaled to the studio XLR plate, and the mono line inputs are normaled to the multitrack outputs. The analog inserts on the mic inputs are all brought out to a patch panel. The Control room mic and guest mic go through external mono pre/processors and come in on faders 7 & 8. The last two faders (17 & 18) are fed from stereo mic pres for uses like drum overheads, keyboards, computers, etc. Using the snapshot feature, the console can be switched from tracking mode to mixdown with only 2 keystrokes. As far as features and sound quality, this quarter century old console can still hold its own against most modern broadcast consoles. These are at the age where many of the caps are failing, but fortunately it's not too difficult to replace them. Some of the metalwork on these consoles had faulty plating, I've seen a number of examples of the plating flaking off. Not really a big deal, but doesn't look good. I have the matching studio talkback box, which is a nice option to use with the studio talent. Currently still using the hot running on-board power supply, but I have 3 of the outboard rackmount supplies to build the auto-redundant setup. Still need to build the cables for that. I'm trying to build an inventory of spare modules to keep this console running well into the future. The On-Air 2000M2 console is underappreciated in my opinion and can be successfully used in many situations, not just broadcast.