Le_Chamois « Mediocre product even dangerous »
Published on 01/04/13 at 23:40I have actually the model PC 1000 W
Entry level product.
Far from ADB or Robert Juliat
Problems: supply with integrated fuse. Overheating when the beam is set to minimum aperture. The plug fully into the socket and stays stuck.
Top lamp unit near power son. Melting insulation and short circuit. Cut to differential protection. End of the service as the problem is not identified.
Solution: Ask a wedge that will stroke limiter to create a space between the lamp unit and the bottom dun projector in order not to overheat the son of supply.
Moving the power input into an angle while the integrated fuse suprimant; protection being on the power blocks.
Since the improvements above, no problem.
Not enough light puisqsance compared to upscale. Is the bulb included which is less powerful?
Warning: the projector body is burning in less than 5 min.
I do not rachetterai this projector.
Entry level product.
Far from ADB or Robert Juliat
Problems: supply with integrated fuse. Overheating when the beam is set to minimum aperture. The plug fully into the socket and stays stuck.
Top lamp unit near power son. Melting insulation and short circuit. Cut to differential protection. End of the service as the problem is not identified.
Solution: Ask a wedge that will stroke limiter to create a space between the lamp unit and the bottom dun projector in order not to overheat the son of supply.
Moving the power input into an angle while the integrated fuse suprimant; protection being on the power blocks.
Since the improvements above, no problem.
Not enough light puisqsance compared to upscale. Is the bulb included which is less powerful?
Warning: the projector body is burning in less than 5 min.
I do not rachetterai this projector.