framby
Published on 09/20/07 at 10:50
Well, this is a 15 watt all-tube.
-3x 12AX7 and 2x for prampli EL84 power for the Tagus.
-2 Between Hi and Lo to the level of output of your scratch.
-2 Channels: Clean and Drive.
3-band EQ common + a + Tone SETTING THE reverb.
Hp-10 "Custom Driver Jensen
-Hp 8-16 ohm output, effects loop, making footswich FS2.
The box offers a compact design for a good impression of solidity.
The rear is being protected by a grid Vitantis CHAC intepestif lamps.
The bte weighs only 14kg, as it features a single 10-hp "... Ok, it's not standard but it is a Jensen!
UTILIZATION
Tres simple! The manual is superfluous!
Specifically, the operating range of the knobs is efficiency.
It's a tube amp ... the sound is!
Rgler the rest to your liking!
SOUNDS
Bin, with a Fender Jaguar Japan, it really gets a standard palette of sound.
Crystal clear light of a little distortion through dirty jugs gnreux.
The funk? No fear! Good attack and rich mdium.
Pop rock? You bet! As a letter in the mail.
Metal? Uh ... OK, but adding a PDAL.
Epiphone SG with a lot of versatility is pert ...
The distortion is a little more muscle and gaining DEFINITIONS.
By pushing the amp into a corner, we get a good sound typical AC / DC.
With a crunch gnreux all s'avre formidable blues.
OVERALL OPINION
I use it for a month and I do not spend more!
The transistors seem bland now ...
I tried a Vox ac-15 and a Fender Blues Junior before I DCID for Laney.
The first 2 both typs too. (Fender fender make a hand ...)
100-200 for less than its competitor, this amp is worth its weight cacahute!
Submit an all-tube amp, "made in England", is under 500 ... I say bravo!
And if the volume you miss it fits easily in a 4x12 or firms in the same extension SERIES available in 1x12 or 2x10 for 200.
I do it again this election about 853 227 times!
After I return can be see ... concurence
-3x 12AX7 and 2x for prampli EL84 power for the Tagus.
-2 Between Hi and Lo to the level of output of your scratch.
-2 Channels: Clean and Drive.
3-band EQ common + a + Tone SETTING THE reverb.
Hp-10 "Custom Driver Jensen
-Hp 8-16 ohm output, effects loop, making footswich FS2.
The box offers a compact design for a good impression of solidity.
The rear is being protected by a grid Vitantis CHAC intepestif lamps.
The bte weighs only 14kg, as it features a single 10-hp "... Ok, it's not standard but it is a Jensen!
UTILIZATION
Tres simple! The manual is superfluous!
Specifically, the operating range of the knobs is efficiency.
It's a tube amp ... the sound is!
Rgler the rest to your liking!
SOUNDS
Bin, with a Fender Jaguar Japan, it really gets a standard palette of sound.
Crystal clear light of a little distortion through dirty jugs gnreux.
The funk? No fear! Good attack and rich mdium.
Pop rock? You bet! As a letter in the mail.
Metal? Uh ... OK, but adding a PDAL.
Epiphone SG with a lot of versatility is pert ...
The distortion is a little more muscle and gaining DEFINITIONS.
By pushing the amp into a corner, we get a good sound typical AC / DC.
With a crunch gnreux all s'avre formidable blues.
OVERALL OPINION
I use it for a month and I do not spend more!
The transistors seem bland now ...
I tried a Vox ac-15 and a Fender Blues Junior before I DCID for Laney.
The first 2 both typs too. (Fender fender make a hand ...)
100-200 for less than its competitor, this amp is worth its weight cacahute!
Submit an all-tube amp, "made in England", is under 500 ... I say bravo!
And if the volume you miss it fits easily in a 4x12 or firms in the same extension SERIES available in 1x12 or 2x10 for 200.
I do it again this election about 853 227 times!
After I return can be see ... concurence