k20015 « Good for beginners »
Published on 06/05/13 at 09:55Initially I bought it because it was cheap and it allowed me to record guitars and a bass direct sound and put a vst.
Finally I used Cubase 5:
- Record voice on XLR
- Recording guitars through an instrument mic XLR input
- Record low through a pre-amp Ashdown then XLR
- Recording guitar and bass on the DI
UTILIZATION
The drivers are stable only if you use the POD Farm provided and not a cracked version.
Noise level gate: no worries
Latency Level: low
I can record two tracks simultaneously: eg singing with a guitar DI.
GETTING STARTED
Very easy to use. Easy installation.
OVERALL OPINION
I use it for 3 years but I use it almost over.
In fact I now use a Motu 828 MKII which allows me to record more instruments simultaneously. And I bought it mainly for its much lower THD than the Line 6. If I want to make good decision that will be sent in a studio for the re-amp + mix + master, I need the lowest possible THD.
Finally I used Cubase 5:
- Record voice on XLR
- Recording guitars through an instrument mic XLR input
- Record low through a pre-amp Ashdown then XLR
- Recording guitar and bass on the DI
UTILIZATION
The drivers are stable only if you use the POD Farm provided and not a cracked version.
Noise level gate: no worries
Latency Level: low
I can record two tracks simultaneously: eg singing with a guitar DI.
GETTING STARTED
Very easy to use. Easy installation.
OVERALL OPINION
I use it for 3 years but I use it almost over.
In fact I now use a Motu 828 MKII which allows me to record more instruments simultaneously. And I bought it mainly for its much lower THD than the Line 6. If I want to make good decision that will be sent in a studio for the re-amp + mix + master, I need the lowest possible THD.